LED OT Light Controller Suitable for both 24v and 12v variant. It is specially developed for LED OT Light .
-11%
Led Operation Theater Ot Light Controller 24v/12v (R7001-lcd) (Pack of 1)
₹2,800.00 ₹2,500.00
SKU: 261249
Categories: B2B, BASIC ELECTRONIC COMPONENTS, CONTROLLERS, DISPLAYS, ELECTRONIC COMPONENTS, ELECTRONICS ACCESSORIES
Additional information
Weight | 0.250 kg |
---|---|
Dimensions | 6 × 4 × 2 cm |
Reviews (0)
Be the first to review “Led Operation Theater Ot Light Controller 24v/12v (R7001-lcd) (Pack of 1)” Cancel reply
Related products
Drv8825 Stepper Motor Driver with Aluminum Heat Sink
BOARDS, CONTROLLERS, ELECTRONICS ACCESSORIES, KITS, KITS, MECHANICAL ROBOTIC PARTS, MOTORS, ROBOT KITS, B2B, ELECTRONIC COMPONENTS, ELECTRONIC MODULES
El817 Evelight Optocoupler Ic Dip-4 (Pack of 10)
Burg Stick 40 Pin Pcb Male Pin Header Strip Connector ( Pack of 10)
Tsop 38 Mhz Ir Receiver Pcb Remote Control Sensor Module Microcontroller (Pack of 10)
1k Ohm Cermet Preset Variable Resistor (Pack of 10)
2 Pin Pcb Mount Screw Terminal Block Connectors 128 (Pack of 10)
M7 1000v 1a Rectifier Diode Smd (Pack of 10)
Wireless Transceiver Module NRF24L01+ 2.4GHZ – for Arduino MCU/ARM/PIC/AVR/STM32 (Pack of 1)
wireless Transceiver module is an easy and suitable module if you want to setup your wireless communication system with low cost!! This module can achieve a good balance between wireless transition performance and cost!Only require an external inductor in the antenna matching There is no need multi-layer PCB. 5V tolerance level inputs. Improved ShockBurst and the serial interface can be easy to connect with a variety of low-cost MCU. There si no need SPI interface with the MCU. Received in the rate of 2Mbit/s, the peak current is 12.5mA.You can easily add it with your own MCU/ARM/PIC/AVR/STM32 system! 2Mbit/s, 1Mbit/s, 250Kbit/s, three selectable transmission rate. MultiCeiver hardware and six receiver functions. 2 Mbit/s make high-quality VoIP is possible. +/- 60 ppm crystal.When the rate of 2Mbit/s @ 0dBm output,the peak current is 11mA. Power-down mode, power consumption is 400nA. Standby mode, power consumption is 32uA. 130us fast switching and wake time.With voltage regulator:Oltage regulators on board. Built-in
10 Segment Digital Red Led Bar Graph Display Ultra Bright (Pack of 10)
12x12x12mm Tactile Push Button Switch (Pack of 10)
470uf 16v Electrolytic Capacitor (Pack of 10)
Capacitor Aluminium Electrolytic 47uf 100v Sk-47uf/100v (Pack of10)
Rated 4.00 out of 5
5v One Channel Relay Module Relay Switch With Opto Isolation High Low Level Trigger Compatible With Arduino Raspberry Pi Arm Avr (Pack of 1)
220uf 50v Electrolytic Capacitor (Pack of 10)
10K PRESET FOR BREADBOARD AND ARDUINO PROTOTYPING (MAKE BOURNS) (Pack of 10)
Rated 2.00 out of 5
Reviews
There are no reviews yet.